Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
config:start [2023/01/30 06:47] rajit [Generic configuration settings] |
config:start [2023/06/25 11:13] rajit [Generic configuration settings] |
||
---|---|---|---|
Line 88: | Line 88: | ||
</ | </ | ||
This specifies a limit on array sizes that also have internal sub-connections (i.e. arrays that are not just simple memories, for example). The limit should be increased as needed, but can have a performance impact if you have a very large array with internal sub-connections. | This specifies a limit on array sizes that also have internal sub-connections (i.e. arrays that are not just simple memories, for example). The limit should be increased as needed, but can have a performance impact if you have a very large array with internal sub-connections. | ||
+ | |||
+ | === Warnings === | ||
+ | |||
+ | The following warnings can be turned on/off using an ACT configuration setting. They can also be adjusted via the standard act [[stdoptions: | ||
+ | * '' | ||
+ | * '' | ||
+ | * '' | ||
+ | * '' | ||
+ | * '' | ||
+ | |||
=== Output generation and name mangling === | === Output generation and name mangling === | ||
Line 102: | Line 112: | ||
end | end | ||
</ | </ | ||
+ | |||
+ | < | ||
+ | begin act | ||
+ | int output_window_width 72 | ||
+ | end | ||
+ | </ | ||
+ | For tools that use pretty-printing, | ||
Line 164: | Line 181: | ||
* '' | * '' | ||
* '' | * '' | ||
+ | * '' | ||