Differences
This shows you the differences between two versions of the page.
Both sides previous revision
Previous revision
Next revision
|
Previous revision
Next revision
Both sides next revision
|
config:start [2023/04/11 10:23] rajit [Technology-specific configuration] |
config:start [2023/06/25 11:13] rajit [Generic configuration settings] |
end | end |
</code> | </code> |
| |
| <code> |
| begin act |
| int output_window_width 72 |
| end |
| </code> |
| For tools that use pretty-printing, this sets the output window width for a line break. |
| |
| |
* ''layout.conf'': [[config:layout|Layout]] generation from netlist. | * ''layout.conf'': [[config:layout|Layout]] generation from netlist. |
* ''lint.conf'': [[config:lint|linting]] configuration for analyzing SPICE simulation traces. | * ''lint.conf'': [[config:lint|linting]] configuration for analyzing SPICE simulation traces. |
* ''models.sp'': In the standard technology configuration directory, the file ''models.sp'' should exist if mixed-signal and analog modeling is to be used. This particular file should include the SPICE commands necessary to include all the device models needed for simulation. This is typically a single line of the form ''.lib <path-to-models> TT'' | * ''models.sp'': In the standard technology configuration directory, the file ''models.sp'' should exist if mixed-signal and analog modeling is to be used. This particular file should include the SPICE commands necessary to include all the device models needed for simulation. This is typically a single line of the form ''.lib "<path-to-models>" TT'' |
| |